GUIDA ALL'INSTALLAZIONE

Come installare una lampada a sospensione

Before you begin:

Always switch off the main power supply from the electrical panel to avoid any risk. It is strongly recommended to have the installation carried out by a qualified electrician. If the canopy or metal parts of the lamp are untreated, wearing gloves is helpful to prevent fingerprints.

Recommended bulbs

For shade Ø 20 cm: E27 bulb, max 25 W, warm light (2700 K)

For Ø 30 / 35 / 40 cm: E27 bulb, max 40 W, also 2700 K

Tools required

  • Drill or screwdriver
  • Wall plugs (rawlplugs)
  • Ceiling hook

Installation steps

  1. Turn off the main power at the electrical panel.
  2. Install a hook in the ceiling using the appropriate wall plug.
  3. Under the canopy, locate the steel wire and unscrew it (clockwise) until the canopy can slide along the wire, giving access to the interior.
  4. Adjust the length of the steel wire to the desired height. Create a small loop so the canopy can sit as close as possible to the ceiling, then secure the closing mechanism by tightening the side screws.
  5. Adjust the length of the electrical cable, then connect the wires (typically black to black, white to white, green/copper to the ground wire) using a terminal block.
  6. Position the canopy: push the small spring underneath it while lifting the canopy toward the ceiling, then screw the threaded part back in place by turning it counterclockwise.
  7. Screw the recommended bulb into the socket.
  8. Attach the glass shade: tighten the screws gently—they should only touch the glass, not apply too much pressure.
  9. Restore power and switch on the light to make sure everything works correctly.
GUIDA VIDEO RAPIDA

Scopri quanto può essere semplice l'installazione

GUIDA ALL'INSTALLAZIONE

Come installare Lampada da tavolo

Before starting:

Make sure the lamp is unplugged. Handle glass components carefully and avoid overtightening any screws to prevent damage.

Assembly steps

  1. Insert the bulb into the lamp base while the lamp is unplugged. Choose the recommended bulb for your model and screw it gently into the socket.
  2. Place the glass sphere onto the base. Position it so that the opening aligns correctly with the mounting structure inside the base.
  3. Tighten the internal screws to secure the sphere. Locate the small screws inside the lamp structure and tighten them evenly until the glass sphere is held firmly in place. Do not overtighten — the screws should only touch the glass enough to keep it stable.
  4. Check stability. Gently adjust the sphere to ensure it sits correctly and does not wobble.
  5. Plug in the lamp and test it. Switch it on to confirm the installation is complete.